Emerson Process Management ROSEMOUNT 5300 Uživatelský manuál stáhnout pdf (Strana 159)

Reference Manual

00809-0100-4530, Rev BA

July 2009

7-29

Rosemount 5300 Series

CHANGING A PROBE

Probe and Firmware

Compatibility

Transmitter heads with a firmware version earlier than 1.A4 (manufacturing

date before 2008-06-18) are not compatible with HP/HTHP/C probes marked

with R2.

Transmitter heads with a firmware version 1.A4 or later are compatible with

HP/HTHP probes without the R2 marking when the Trim Near Zone function

is performed, as illustrated below.

Only probes with the VC marking are compatible with the Dynamic Vapor

Compensation function. See Appendix C: Advanced Configuration to

determine if the Dynamic Vapor Compensation function is supported by the

transmitter head.

Table 7-1. Compatibility

between probe type and

firmware version

Compatibility Between Probe Types and Firmware Versions

Firmware Version Probe Type

Standard HP / HTHP without

R2 marking

HP / HTHP / C with

R2 marking only

(1)

HTHP with both

R2 and VC marking

(1)

Firmware version earlier

than 1.A4

Yes Yes No No

Firmware version 1.A4

Yes Yes

(2)

Yes No

Firmware version 2.A2 or

later

Yes Yes

(2)

Yes

(3)

Yes

(4)

(1) The R2 marking is on the housing seal or the adapter as seen in the figure.

(2) Trim Near Zone function is required.

(3) When Dynamic Vapor Compensation is not used.

(4) The probe requires that Dynamic Vapor Compensation is activated in the device for full functionality.

R 2

R2 VC

1 2 ... 154 155 156 157 158 159 160 161 162 163 164 ... 323 324

Komentáře k této Příručce

Žádné komentáře

Emerson Process Management ROSEMOUNT 5300 Uživatelský manuál Strana 159

Komentáře k této Příručce

Související produkty a manuály pro Měření, testování a kontrola Emerson Process Management ROSEMOUNT 5300